Back to previous page
Bluetooth DUN Set-up Using WIDCOMM Bluetooth Software
- On the Bluetooth Setup screen, make sure the first option is selected and click Next to continue.
- On the Bluetooth Service Selection screen, select Dial-up Networking and click Next to continue.
- On the Bluetooth Device Selection screen, you must run your handset in Discoverable mode. To turn your device to Discoverable mode, find your device using the instructions in the Make Your Device Discoverable section. Select the device you wish to enable for Dial-Up Networking and click Next to continue.
- Click Finish to finalize the set-up process and connect to your device.
- After you've finished the set-up process, you will be requested to create a paired relationship by entering a PIN code. Once the code has been entered, click OK to continue.
A pairing request should display on your device. Select Yes to accept, then enter the PIN code to authenticate the connection. Press OK to continue.
If the PIN was accepted, you will see the message Paired Successfully. Press OK to continue. On the screen Paired Devices, you can verify that the device has been successfully enabled to connect to the laptop.
- From VZAccess Manager, select My device is paired and is ready to be detected, and then press Next to continue.
VZAccess Manager will now detect your Bluetooth-enabled device.
- Once VZAccess Manager is configured to use your modem, press Next to continue.
- Enter your mobile device phone number and press Next to continue.
- Select Finish to complete the VZAccess Manager process.
Connecting to Your Device
- From the VZAccess Manager menu screen, press the Connect WWAN button.
- Press Continue to establish a BroadbandAccess or NationalAccess connection.
After pressing Continue, you will instantly be connected.
Prev |
Next (Page 2 of 4)